Temperature Humidity Test Equipment .pdf
64L~1000L Lab Environmental Programmable High Humidity Temperature Chamber for Climatic Simulation
7” LCD controller with English interface
Inner made of SUS#304 stainless steel material
Meet all requirements for extreme testing and low temperature alternating
One access port (Dia.50mm)on the left side of chamber
USB date store and optional RS232
Programmable Temperature Cycling Equipment is to provide high and low temperature and humidity constant, high temperature and humidity alternating test environment, it can accurately simulate low temperature, high temperature, high temperature and humidity, low temperature and humidity and other complex natural environment. Including refrigeration system, heating system, humidification, dehumidification, waterway system, air duct system, control system, system by safety protection device.
Temperature Humidity Chamber Technical Parameter:
|External Dimension WxHxD (mm)
Low Temperature(A:25°C B:0°C C:-20°C D:-40°C E:-60°C F:-70°C)
High Temperature 150°C
||20%~98%R.H.(10%-98% R.H. / 5%-98% R.H ,is optional , need Dehumidifier)
|Indication relolution/ Distribution uniformity of temperature and humidity
||0.1°C; 0.1% R.H/±2.0°C; ±3.0% R.H.
|Control Accuracy of Temperature and Humidity
||±0.5°C; ±2.5% R.H.
|Temperature Rising/ Falling Velocity
Temperature rising approx. 0.1~3.0°C/min ;
temperature falling approx. 0.3~1.0°C/min;
( Falling Min.1.5°C/min is optional)
|Inner and Outer Material
||Interior material is SUS 304# stainless steel, exterior is stainless steel or SEE cold-rolled steel with paint coated.
||Resistant to high temperature, high density, formate chlorine, ethyl acetum foam insulation materials
||Wind cooling or water cooling, (single segment compressor-40°C, double segment compressor -70°C)
||Fuse-free switch, overloading protection switch for compressor, high and low voltage coolant protection switch, over-humidity and over-temperature protection switch, fuses, fault warning system, water short storage warning protection
thermal cycling temperature impact test device Control system:
1.Imported LCD display screen, capable of displaying the measured value as well as the set value and time.
2.Fixed condition or programmable condition can be set.
3.Fixed condition setting time range: 999 H
4.Programmable mold can set 120 different programe at the same time, each programe can set serverial segement to do cycle testing
"5.Each prgrame can have max.50 segement with different temperature setting,segement runing time
Max.530 H99M , Max.can do 999 times cycle."
6.With power off memory device, reply message to continue with the rest of the program.
Pictures for reference: